|
Thread: REPU & other Rotary Parts
[' This thread is 5 pages long:
1
2 (3)
4
5 '] |
top1usa
Redlining
Posts: 264
|
posted April 13, 2013 06:23 AM |
|
Hang in there...
quote: Well I ended up getting to keep all my toys! Unfortunately I had to sell my house which I completely remodeled from the studs out but oh well. I'll be moving all of my REPU parts to a new location this week. I'll then update my list with what I still have and reply to those that have inquired about parts. Thanks for your patience.
No fun going through what you just went through but glad is over(I hope)! Once you settled down....post up what you have left. Will need few things.
____________
74' Mazda Repu-Flare
yellow
85' Toyota ae86-Red-SOLD
88' Toyota ae92-Gray
14' Toyota Prius
|
|
rotarydave2006
Revvin Up
Posts: 53
|
posted April 13, 2013 11:33 AM |
|
I'm interested in a tailgate if you happen to have one email me rotarydave2006@yahoo.com
|
|
repumax
Redlining
Posts: 427
|
posted April 24, 2013 09:01 AM |
|
Back up for sale with updated list
Updated List
REPU Specific:
3 - Passenger Doors $75 each
1 - Drivers Door $100
1 – Tailgate $50
1 - Left Fender $50
1 - Right Fender $50 (Sale Pending)
2 – Grills $50 each
1 – Set Left & Right bumper end caps $200
2 - Stainless Hood Trim $50 each
4 - Door Glass $20 each
2 - Fan Shrouds $25 each
1 - Oil Cooler $40
1 - Trans. Cross Member Modified for 2nd Gen Trans. $25
1 - Super Clean Alternator and Voltage Regulator (removed from my truck) $50
1 - Air Cleaner Canister $25
1 – Stereo Surround (cut for modern stereo) $25
3 - Metal Dash (sits below windshield) $10 each
1 - NOS in box Hood Release Lever $25
1 - Complete rear end with 4.375 Ratio $100
1 - Rear End Housing with axles (no diff.) $40
1 - Hood (super clean) $200
1 – Hood (damaged but repairable) $50
1 - Steering Wheel $40
2 - Steering Columns with Shaft $20 each
1 - Steering Box $40
1 – Driveshaft $40
4 – Spindles $20 each
1 - Sway bar $10
3 - Steering Center Link & Tie Rod's $20 each
1 - 4 Speed Ribcase Transmission with no Bell Housing
(Removed from 70,000 mile REPU) $50
1 - New Set of Rear Brake Drums and Shoes $100.00 for all
Other Rotary Parts:
2 - 13B S4 N/A Core engines (short blocks) $50 each
1 – FB Distributor with Igniters $50
1 – Set of FB Coils $40
1 – 12a Front Cover $25
1 – Super Clean S4 Alternator $50
1 – Not so clean S4 Alternator $25
2 – S4 N/A UIM and LIM $10 each
1 - GSL-SE Flywheel, Clutch and Pressure Plate $40
1 - GSL-SE (NOS in box) Front Engine Cover $100.00
1 – Set of 4 S4 Coil Overs. Includes: 4 - Perch’s, 2 - 400lb springs and 2 - 50lb
springs. $100 for all
1 - Set RX7 S4 Fenders $25 each
1 - Set RX7 S4 Doors $25 each
1- RX7 S4 Pedal Assembly (manual) $25
I’m located in North San Diego County and again, I will not ship any large items. Please send me a PM with your email address if you would like pictures of anything.
PayPal accepted. Thanks for looking!
|
|
rotarydave2006
Revvin Up
Posts: 53
|
posted April 25, 2013 12:53 PM |
|
Sent email regarding tailgate thanks
|
|
repumax
Redlining
Posts: 427
|
posted April 26, 2013 03:06 PM |
|
Tailgate is sold to rotarydave2006.
|
|
ford302
Newbie
Posts: 4
|
posted May 02, 2013 11:30 AM |
|
If you still have the right and left fenders and doors for sale could you please e-mail pictures @ suerambold@gmail.com
|
|
martin
Newbie
Posts: 1
|
posted May 02, 2013 05:36 PM |
|
hood ( super clean)
Do u still have the Hood? IF you do i'll buy it from you contact me at Martinalberto4u@aol.com
|
|
Smigjo
1st Gear
Posts: 19
|
posted May 04, 2013 02:17 PM |
|
Will the S4 pedal assembly fit a Repu?
____________
1975 Repu with Hitachi
carb, auto.
|
|
mazdarx605
Redlining
Posts: 314
|
posted May 14, 2013 10:24 AM |
|
I am interested in a lot of things, but shipping may be tough depending on where you are. My guess is not on the East coast where I live. What is your location? Any way you could ship some of the small stuff together to save on shipping. I could use the oil cool, fan shroud, a hood, but that isn't going to ship, and several other things.
|
|
repumax
Redlining
Posts: 427
|
posted May 15, 2013 06:54 AM |
|
quote: I am interested in a lot of things, but shipping may be tough depending on where you are. My guess is not on the East coast where I live. What is your location? Any way you could ship some of the small stuff together to save on shipping. I could use the oil cool, fan shroud, a hood, but that isn't going to ship, and several other things.
quote: I’m located in North San Diego County and again, I will not ship any large items. Please send me a PM with your email address if you would like pictures of anything.
quote:
I have two hoods. Sale is pending on the nicer one and the other needs work. I also have an oil cooler and shroud. What else do you need?
|
|
nlsolja123
Newbie
Posts: 2
|
posted May 20, 2013 05:15 AM |
|
I want the rear diff and gears
|
|
top1usa
Redlining
Posts: 264
|
posted May 23, 2013 08:22 AM |
|
rear side marker lights...
Max.... do you have the 2 rear side red marker lights assembly? If so, please provide pics and how much?
____________
74' Mazda Repu-Flare
yellow
85' Toyota ae86-Red-SOLD
88' Toyota ae92-Gray
14' Toyota Prius
|
|
Xp882
Redlining
Posts: 294
|
posted May 23, 2013 02:40 PM |
|
Hey max can you send a pic of that trans crossmember will it work with a t2 trans? Awright84@verizon.net
|
|
repumax
Redlining
Posts: 427
|
posted May 24, 2013 06:36 AM |
|
quote: Max.... do you have the 2 rear side red marker lights assembly? If so, please provide pics and how much?
Sorry I don't have any.
quote: Hey max can you send a pic of that trans crossmember will it work with a t2 trans? Awright84@verizon.net
I'm not sure but I'll send you a pic.
|
|
top1usa
Redlining
Posts: 264
|
posted May 24, 2013 08:16 AM |
|
oh well...
Thanks Max for your update... search goes on!
____________
74' Mazda Repu-Flare
yellow
85' Toyota ae86-Red-SOLD
88' Toyota ae92-Gray
14' Toyota Prius
|
|
sdrotary
1st Gear
Posts: 12
|
posted May 25, 2013 11:35 AM |
|
Id like the trans crossmember please. I am in east sd
____________
1979 RX-7
1975 REPU
1988 Turbo II
2004 Mazda 6s
|
|
repumax
Redlining
Posts: 427
|
posted May 28, 2013 07:28 AM |
|
quote: Hey max can you send a pic of that trans crossmember will it work with a t2 trans? Awright84@verizon.net
Pics sent Adam.
quote: Id like the trans crossmember please. I am in east sdquote:
You're second if Adam doesn't want it.
|
|
repumax
Redlining
Posts: 427
|
posted May 29, 2013 09:46 AM |
|
quote: Id like the trans crossmember please. I am in east sd
Ok Adam doesn't want it so its up for grabs. Send me a PM with your email and I'll send you some pics.
|
|
katsuo
1st Gear
Posts: 16
|
posted July 27, 2013 03:11 PM |
|
abou parts
I am lookin for both side of fenders,doors, and a bed.
If you have them, please send me some pictures and tell me about the price.
Thanks.
|
|
katsuo
1st Gear
Posts: 16
|
posted July 31, 2013 06:11 AM |
|
Do you have fenders, both side of doors, bed, and rear window?
IF You have them, please send some pictures.
Thanks.
|
|
All times are PST (US)
[' This thread is 5 pages long:
1
2 (3)
4
5 '] |
|
|