[REPU] Board Post Reply: Easy way to lower

From: Daemon user for apache (wwwrun@rotor.mazzella.org)
Date: Fri Aug 23 2002 - 10:38:51 PDT

A New Post has Been made to the thread [Easy way to lower]
The Reply was:

[b]Most any good automotive spring shop (Landrum Spring in ATL comes immediately to mind) can wind you up a set of replacement short springs. They can also de-arch the rear springs. Prices are real reasonable.

I have yet to find a set of drop spindles to fit a REPU, or similar B series/Courier. They may be out there, but I've not found them.

An alternate possibility would be coil overs from Pro-Formance shocks, or Carrera, both located in ATL. Remove all but the main leaf on the rear springs, using the main leaf for locating the rear end. The front will require a little more work, but should still be pretty easily done.[/b]


  Log into http://http://www.mazdarepu.com/board
Go Here to Reply: http://www.mazdarepu.com/board/viewthread.php3?FID=8&TID=6
Mazda Rotary Engine Pickup List http://mazdarepu.com
To get off the list send an email to majordomo@mazdarepu.com

This archive was generated by hypermail 2.1.1 : Mon Jan 27 2003 - 00:00:09 PST