|
|
Thread: Can't Stand It, It's to Quiet.
|
spokanerxdude
Hauling
Less cubes... More balls
Posts: 181
|
posted September 14, 2013 04:24 AM |
|
Can't Stand It, It's to Quiet.
Well in the next week or two I'm going to be putting GM TBI and Megasquirt on the REPU. Tired of messing with the carbs. Will see if I can put together a wright up on how to do this if anyone is interested. Going to try and keep it as stock looking as possible, About the only thing that will stick out is the 2nd gen RX-7 CAS and 4 2nd gen RX-7 coils. going to figure out a way to use the stock air cleaner. Well I'm at work so time to go pass gas and drag my hose around, more on this later.
____________
Allen Ervin, spokanerxdude@yahoo.com
509-998-9024
|
|
sparky
Redlining
Posts: 299
|
|
posted September 17, 2013 05:53 AM |
|
Very Interested....
I would like to squirt mt truck someday and run a supercharger. Are you going with MS-2 or MS-3?
____________
'77 REPU
Stock 6-port
T-2 tranny
Weber IDA 48
Alum Flywheel
3rd gen Torsen in rear end.
DLDFIS ignition
|
|
Brad
Rotorhead
Posts: 1672
|
|
posted September 17, 2013 10:56 AM |
|
SWEET, keep us updated. It is quiet on the forum lately.
Haven't driven my REPU in weeks, too hot and no A/C. Plus another fuel line leak. The hose clamps are self-loosening while the truck sits in the HOT garage. I did clean the plugs though.
|
|
spokanerxdude
Hauling
Less cubes... More balls
Posts: 181
|
|
posted September 18, 2013 04:18 AM |
|
quote:
SWEET, keep us updated. It is quiet on the forum lately.
Haven't driven my REPU in weeks, too hot and no A/C. Plus another fuel line leak. The hose clamps are self-loosening while the truck sits in the HOT garage. I did clean the plugs though.
quote:
Very Interested....
I would like to squirt mt truck someday and run a supercharger. Are you going with MS-2 or MS-3?
Thanks guys now that I know there is some interest It will motivate me more to get this done.
I'm going to use an MS3/MS3X.
____________
Allen Ervin, spokanerxdude@yahoo.com
509-998-9024
|
|
spokanerxdude
Hauling
Less cubes... More balls
Posts: 181
|
|
posted October 25, 2013 10:17 AM |
|
Just a short update, I'm doing a complete wright up later, I have the Intake manifold and adapter modifed and I am now working on sorting out the ms3 wiring need for the setup. Next will be working out the throttle and oil injection linkage, could be fun LOL.
____________
Allen Ervin, spokanerxdude@yahoo.com
509-998-9024
|
|
spokanerxdude
Hauling
Less cubes... More balls
Posts: 181
|
|
posted December 19, 2013 04:48 AM |
|
Been to cold here in Washington to work on the repu, just bought a heater for the shop so will be doing more on this after Christmas and New years. Haven't forgot about this project and have even started working on the wright up just not far enough to post anything yet. TTYL Allen
____________
Allen Ervin, spokanerxdude@yahoo.com
509-998-9024
|
|
|
|
Edited By: 
