I am in need of a rotor housing, if anyone has a spare. I would like to have an early 13B housing to match the rear. After opening the engine up, I have found that my front rotor has lost most of its plating and is not usable. The rear rotor housing is just fine. I will also have to replace the end plates and intermediate plate, but I have them already. Please email me if you have a spare or dead engine that has a good housing. I will post pics in the gallery under charles' restoration.
rotarynews
Moderator
Too Many Rotary Websites
Posts: 206
posted May 01, 2002 09:35 AM
Sorry to hear that!
Sorry to hear about the front... I have a 6 port that the rear went out on.. maybe you could have a frankenstein engine ;) 2 ports in the rear, and 3 ports in the front... a 5 port engine.
Seriously, though... check with your local junk yard. Most of them are connected on a network that connects to others junk yards in the region. You might get lucky... I wouldn't pay more than $50 for a junk yard motor.
posted April 30, 2002 07:49 PM
posted May 01, 2002 09:35 AM
